Electric skateboard hub motor drive board 3 inch brushless DC motor controller

Description

12V24V electric skateboard hub motor drive board 3 inch hub motor 70mm brushless
DC motor controller 150W100W
Do not provide technical support, know how to use in the purchase
The kit includes a remote control handle + driver board.
This is mainly used for scooters. A remote control can link multiple driver boards, that is,
single drive, dual drive, 4 drive and so on.
The method of linking is to first turn the remote control handle to the Brake position and then turn on the
power switch of the remote control handle. The indicator light flashes alternately in red and green, and the
remote control still cannot be released. Then turn on the power switch of the driver board, and then start
linking When the remote control handle indicator is off, the linking is successful. One remote control controls
multiple drive boards and the method of linking is to link one drive board before linking to the next one.
The voltage of this drive should be DC24V- 36V.
The power ： 250W.
Note: This kit itself can only run at low speed. High-speed operation requires modification of the remote
control. Just connect two wires of the remote control button switch to the two cut wires of the circuit board
socket. After refitting, there are 4 gears. The default is low-speed gear. Press down the speed control knob to
change the speed once. Gears 1, 2 and 3 are 3 speeds respectively.
Packing include:
remote control handle + driver board